Coriolis mass flowmeter manufacturer 2025: What is a Mass Flow Meter? A mass flow meter, also known as a mass flow sensor, mass flow meter working principle is measures the flow rate of a fluid based on its mass. The flow rate is determined by the difference between the mass of the fluid entering the meter and the mass of the fluid leaving it. This difference is then taken into account. Due to their direct mass flow measurement, high accuracy, and ability to measure fluids with varying properties, coriolis flow meters are commonly used in this industry. Flow meters with magnetic components can also be used to measure corrosion-resistant fluids, but they are restricted to conductive fluids, and petrochemical products are not conductive. See extra details at coriolis flow meter.
Vortex flow meter is the fluid Reynolds number is within a certain range, and its output is only proportional to the volume flow. The output of vortex flowmeter has frequency signal and analog signal, and the analog output is obtained by f/ conversion on the basis of frequency output. This conversion loses about 0.1% accuracy. Therefore, when it is used to measure the steam flow, users prefer to use the frequency output. There are several other reasons why frequency output vortex flowmeters are more popular with users such as thermal companies.
The selection of gas turbine flowmeters is a difficult task for many people. In fact, as long as the relevant precautions are mastered, the selection of gas turbine flowmeters will become very simple. Fully understand the qualifications and performance of gas turbine flow meter suppliers. When purchasing gas turbine flowmeters, imported brands are basically familiar to everyone. However, when purchasing domestic brands, it is necessary to fully understand the qualifications and performance of suppliers. You can get a first-hand account of it by visiting it in person or by asking people who have used the brand before. It is recommended to use brands with high reputation in China, good user reputation and outstanding performance as much as possible.
Fork density meter can measure the density, concentration, gravity, temperature, and accuracy of liquids without being affected by temperature, pressure, density, and viscosity. Applications of micro motion fork density meter: Pipeline interface inspection, slurry solids monitoring and corrosive acid concentration control; density and concentration monitoring that require rapid response. Continuously measure pipelines in real-time through pipelines and storage tanks to increase installation flexibility and choose from a variety of corrosion-resistant materials to measure the density and concentration of key chemicals. Supports protocols connected to DCS, PLC and flow computers. Pass Hazardous Area Approved Head-Mounted Transmitters extend the range of use, the transmitter supports local configuration and display. Read additional info at https://www.bjssae.com/.
Beijing Sincerity Automatic Equipment Co., Ltd was reformed from the Petrochemical Branch Automatic Equipment Co.,Ltd. Beijing Sincerity is the innovation developed enterprise invested by both the China Petroleum &Chemical Corporation’s Beijing Research Institute of Chemical Industries and the Capital Science and Technology Group. Please be noticed, that all the videos taken are approved by SGS, Switzerland, or TUV, Germany. All the videos are real and without shooting skills or beauty filters.
Install the total steam flow meter before the pressure reducing valve. Since the above-mentioned steam has not been decompressed, there is no phase change problem, so install the flowmeter before the pressure reducing valve, and use the saturated steam compensation method to ensure the measurement Accuracy. If the flowmeter can only be installed behind the pressure reducing valve, a pressure transmitter can be added for temperature and pressure compensation. If the stability of the pressure reducing valve is good, the upstream pressure value of the flowmeter can be set as a constant value in the display instrument for temperature and pressure compensation.
Day for day vast quantities of oil and gas are transported across the globe, refined and transported further. Mature and foolproof technology is essential. But it is the control through instrumentation and visualisation that help make all these processes safe and reliable. The Coriolis Insertion Density Meters could be used for the detection of the liquid’s density. The insertion density meters are the best choices for the proccess control as the basic parameters of density, and also for the quality control with the solid percentage or the concentration for references.